x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
The new v2.1 part cooling fan shroud is a significant upgrade to the cooling system on your print head. Designed to wrap fully around the nozzle, it delivers 360° part cooling for dramatically improved print quality, especially on overhangs, bridges, and fine details.
The shroud is a 3D printed part, and it is recommended to be printed in ABS.
The fan shroud is secured using an M4×12mm socket head bolt, which replaces the existing M4×6mm bolt used to mount the servo. The longer bolt passes through both the fan shroud and the servo mounting point (lower left) simultaneously, clamping both components in a single fixing.
Note: After installation, re-run the EDDY_CAL macro to recalibrate the eddy current probe.
Hardware required:
1× M4×12mm socket head bolt (replaces the existing M4×6mm servo bolt)
The STL should be oriented in the slicer exactly as shown in the image below. Use support from build plate only and do not enable supports everywhere, as internal supports are difficult to remove and unnecessary with this orientation.