
Upgrade: High Speed Part Cooling Fan
Easy10 to 15 min3 steps
- Note: Remove the old fan and mount the new one in its place.
- Note: Wire according to the diagram.
Loading comments…
- Note: In Mainsail open up the printer.cfg file.
- Note: Scroll down to the [fan] section and replace the values with these:
- Reminder: pin: PE5 max_power: 1.0 hardware_pwm: True cycle_time: 0.00004 shutdown_speed: 0 kick_start_time: 0.1
Loading comments…
- Note: The fan functions in the same way before and with the same commands.
- Note: Setting the fan to 60% should give good results for PLA, with plenty of overhead for bridging and overhang sections.
Loading comments…